Instrument Cluster (Remove and Replace)
Correction code
21050202
1.14
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
- 2023-04-23: Reorganized the procedure.
Remove
- Remove the IP sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).
- Remove the IP passenger air vent. See Air Vent - Instrument Panel - Passenger (LHD) (Remove and Replace).
-
Remove the IP driver air vent . See
Air Vent - Instrument Panel - Driver (LHD) (Remove and Replace).
Install
-
Install the IP driver air vent . See Air Vent - Instrument Panel - Driver (LHD) (Remove and Replace).
- Install the IP passenger air vent. See Air Vent - Instrument Panel - Passenger (LHD) (Remove and Replace).
- Install the instrument panel sub-assembly and all other parts that were removed for access . See Sub Assembly - Instrument Panel (Remove and Install).