17/06/2022 13:38:43

Antenna - MIMO - LH (Remove and Replace)

Correction code 21331102 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  2. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace)
  3. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  4. Remove the driver sun visor. See Sun Visor - LH (Remove and Replace).
  5. Repeat step 1 through step 4 for the RH side of the vehicle.
  6. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  7. Remove the upper quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  8. Release the clips (x5) that attach the front of the headliner to the vehicle.
  9. Disconnect the LH MIMO antenna electrical connectors (x2).
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate the coaxial cable for access to depress locking tabs.
  10. Remove the bolt that attaches the LH MIMO antenna to the body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive inside the antenna housing and cannot be removed from the antenna.
    Tip: Use of the following tool(s) is recommended:
    • T30 bit
  11. Release the clips (x2) that attach the LH MIMO antenna to the body, and then remove the antenna from the vehicle.

Install

  1. Install the LH MIMO antenna to the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the clips (x2) are fully engaged.
  2. Install the bolt that attaches the LH MIMO antenna to the body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive inside the antenna housing.
    Tip: Use of the following tool(s) is recommended:
    • T30 bit
  3. Connect the LH MIMO antenna electrical connectors (x2), and then engage the locking tabs.
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate the coaxial cable for access to depress locking tabs.
  4. Secure the clips (x5) that attach the front of the headliner to the vehicle.
  5. Install the upper quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  6. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  7. Install the passenger sun visor. See Sun Visor - LH (Remove and Replace).
  8. Install the RH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  9. Install the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace)
  10. Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  11. Repeat step 7 through step 10 for the LH side of the vehicle.
  12. Install the lower quad camera cover. See Camera Cover - Lower (Remove and Replace)
  13. Verify the BT, WiFi and LTE are functioning properly.