Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace)
    
    
    
    Correction code
    
                                    13055102
                                    0.06
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
    
  
Remove
- Open the LH rear door.
 - 
          Pull the top of the LH 2nd row seat side bolster forward to release the clip that
            attaches the bolster to the LH C-pillar, and then move bolster up to release the tab
            that attaches the bolster  to the LH lower C-pillar.
          
 - Remove the LH 2nd row seat side bolster from the vehicle.
 
Install
- 
          Inspect the condition of the clip for the LH 2nd row seat side bolster, and replace
            if it is damaged.
          
 - 
          Hook the bottom tab of the LH 2nd row seat side bolster into the LH lower C-pillar,
            and then push the top of the bolster rearward to fasten the clip that attaches the
            bolster to the LH C-pillar.
          NoteHold the LH 2nd row seatbelt toward the center of the vehicle to aid installing the bolster.
 - Close the LH rear door.