2022-12-15

Bracket - Homelink (Remove and Replace)

Correction code 17154212 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
  2. Remove the homelink module, and then set it aside:
    1. Release the locking tab.
    2. Slide the module to the LH side of the vehicle.
  3. Remove the bolt that attaches the homelink bracket to the vehicle, and then remove the bracket from the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm socket

Install

  1. Position the homelink bracket into the vehicle, and then install the bolt that attaches the bracket to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm socket
  2. Install the homelink module.
    1. Release the locking tab.
    2. Slide the module to the RH side of the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    and slide the homelink module towards the left side of the vehicle
  3. Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).