Handle - Emergency Release - Liftgate (Remove and Replace)
Correction code
11404102
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
-
Release the tab that attaches the
liftgate emergency release handle to the trunk trim.
-
Release the locking tab that attaches
the liftgate emergency release handle to the release cable, and then remove the release
handle from the assembly.
Install
-
Install the liftgate emergency release handle onto the release cable assembly.
-
Install the emergency release handle onto the trunk trim.
- Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).