2022-06-17

Substrate - Bolster - Inner - 2nd Row - LH (Remove and Replace)

Correction code 13058502 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat back panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).
  2. Remove the bolt that attaches the LH 2nd row bolster assembly to the back frame.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Release the fasteners that attach the LH 2nd row bolster assembly to the seat assembly, and then remove the bolster assembly from the seat.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lightly squeeze the clips to release the sub-bolster.
  4. Release the Velcro that attaches the LH 2nd row bolster trim to the LH 2nd row seat inner bolster substrate.
  5. Release the clips (x3) that attach the LH 2nd row bolster trim to the LH 2nd row seat inner bolster substrate.
  6. Remove the LH 2nd row seat inner bolster substrate from the bolster assembly.

Install

  1. Install the LH 2nd row seat inner bolster substrate into the bolster assembly.
  2. Fasten the clips (x3) that attach the LH 2nd row bolster trim to the LH 2nd row seat inner bolster substrate.
  3. Secure the Velcro that attaches the LH 2nd row bolster trim to the LH 2nd row seat inner bolster substrate.
  4. Position the LH 2nd row bolster assembly onto the seat assembly, and then fasten the clips that attach bolster to the seat.
  5. Install the bolt that attaches the bolster assembly to the back frame.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Install the LH 2nd row seat back panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).