Back Panel – 2nd Row Seat – LH (Remove and Replace)
Correction code
13082302
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
-
Fold the LH 2nd row seat to the down
position.
NoteIf 2nd row lower seat cushion is not present, protect the seat as required.
-
Release the clips (x10) and fasteners
that attach the LH 2nd row seat back panel to the seat assembly.
NoteSlide the panel up and out of the bottom part of the seat frame.
Install
-
Position the LH 2nd row seat back
panel into the 2nd row seat assembly, and then install the clips (x10) and fasteners
that attach the panel to the assembly.
NoteSlide the panel down and in at the bottom part of the seat frame.
- Fold the LH 2nd row seat to the vertical position.