Seal - Outer Belt - Front Door - LH (Remove and Replace)
Correction code
11703002
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the LH front door and fully lower the LH front window
-
Starting from the rear edge, carefully
lift and roll the LH front door outer belt seal outward to remove it from the door
assembly.
CAUTIONBe careful not to bend or damage the components.
Install
-
Install the LH front door outer belt
seal onto the LH front door assembly.
NoteUse P-80 Emulsion lubricant to lube the seal for easy installation and gap adjustment.
- Raise the LH front window and close the LH front door.