Wheel Arch Liner - Rear - LH (Remove and Replace)
Correction code
12011102
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Move the vehicle to a 2 post lift. See Raise Vehicle - 2 Post Lift.
- Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
-
Remove the push clips (x13) and fan
clips (x3) that attach the LH rear wheel arch liner to the body, and then remove the
liner from the vehicle.
Install
-
Install LH rear wheel arch liner into
the LH rear wheel arch, and then fasten the push clips (x13) and fan clips (x3) that
attach the liner to the body.
- Install the LH rear wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the 2-post lift. See Raise Vehicle - 2 Post Lift.