17/06/2022 13:04:44

Hinge - Door - Front - Upper - LH (Remove and Replace)

Correction code 11336402 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Use a floor jack to support the LH front door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Protect painted surfaces with a soft surface.
  2. Remove the bolts that attach the LH upper front door hinge to the door assembly.
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  3. Remove the bolts that attach the LH upper front door hinge to the body.
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  4. Remove the LH upper front door hinge from the vehicle.

Install

  1. Position the LH upper front door hinge into the vehicle.
  2. Install the bolts that attach the LH upper front door hinge to the body.
    52 Nm (38.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  3. Install the bolts that attach the LH upper front door hinge to the door assembly.
    31 Nm (22.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13mm combination wrench
  4. Remove the floor jack from the LH front door.
  5. Check gap and flushness of the LH front door to surrounding components.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current gap/flush targets.
  6. Use IPA wipes to clean the body side upper hinge bolts.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute of dry time.
  7. Apply touch up paint to the body side upper hinge bolts as necessary.