26/10/2023 01:59:12

Hose - RH Front Sill to Underhood (Remove and Replace)

Correction code 18300062 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-10-26: Reorganized the procedure.

Remove

  1. Enable Service Mode. See Service Mode (Enable and Disable)
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect LV power. See LV Power (Disconnect and Connect).
  4. Remove the RH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  5. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  6. Remove the front skidplate. See Skidplate - Front (Remove and Replace).
  7. Position a coolant drain container under the front of the vehicle.
  8. Release the clip, disconnect the RH sill to underhood hose from the RH side sill to powertrain return hose, then immediately plug both fittings.
  9. Release the clip, disconnect the front drive unit rear powertrain hose from the RH sill to underhood hose, then immediately plug both fittings.
  10. Release the clips (x4) that attach the RH sill to underhood hose to the body.
  11. Remove the RH sill to underhood hose from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of orientation of the hose for installation.

Install

  1. Install the RH sill to underhood hose to the vehicle
    Informational PurposesAn informational icon, calling your attention
    Note
    Pay attention to the orientation of the hose.
  2. Fasten the clips (x4) that attach the RH sill to underhood hose to the body.
  3. Remove the plugs, immediately connect the front drive unit rear powertrain hose to the RH sill to underhood hose, then fasten the clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test on the fittings to make sure that they are secure.
  4. Remove the plugs, immediately connect the RH sill to underhood hose to the RH side sill to powertrain return hose, then fasten the clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test on the fittings to make sure that they are secure.
  5. Remove the coolant drain container from underneath the vehicle.
  6. Install the front skidplate. See Skidplate - Front (Remove and Replace).
  7. Install the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  8. Install the RH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  9. Connect LV power. See LV Power (Disconnect and Connect).
  10. Perform the cooling system (partial refill and bleed) procedure. See Cooling System (Partial Refill and Bleed).
  11. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).