Sensor - Air Temperature - Duct - Driver (Remove and Replace)
Correction code 18109202 1.02 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the IP sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).
- Remove the driver instrument panel duct. See Duct - Instrument Panel - Driver (Remove and Replace).
-
Remove the driver duct air temperature
sensor.
Install
-
Install the driver duct air
temperature sensor.
NoteEnsure the sensor is fully seated into the duct.
- Install the driver instrument panel duct. See Duct - Instrument Panel - Driver (Remove and Replace).
- Install the instrument panel sub-assembly and all other parts that were removed for access . See Sub Assembly - Instrument Panel (Remove and Install).