2022-06-17

12V Power Socket - Center Console (Remove and Replace)

Correction code 17303002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the front center console USB hub. See USB Hub - Center Console - Front (Remove and Replace).
  2. Remove the screws (x2) that attach the center console 12V power socket to the service panel assembly.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 socket

Install

  1. Position the center console 12V power socket onto the center console service panel assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use the alignment tabs to ensure the power socket is correctly positioned.
  2. Install the screws (x2) that attach the center console 12V power socket to the service panel assembly.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 socket
  3. Install the front center console USB hub. See USB Hub - Center Console - Front (Remove and Replace).