2023-01-09

Switch - Hazard - Center Console (Remove and Replace)

Correction code 17407002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the RH front door and lower the RH front window.
  2. Remove the phone dock assembly from the center console. See Phone Dock - Center Console (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove components from the phone dock assembly.
  3. Remove the screws (x5) that attach the center console hazard switch to the phone dock.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Release the clips (x3) that attach the hazard switch to the phone dock, and then remove the switch from the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the clips, and then rotate out of the phone dock.

Install

  1. Position the center console hazard switch into the phone dock assembly, and then fasten the clips (x3) that attach the switch to the assembly .
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate the hazard button into the phone dock by aligning the datums, and then fasten the clips (x3).
  2. Install the screws (x5) that attach the hazard switch to the phone dock assembly.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Inspect the front of the phone dock to ensure that the hazard button module is flush to the phone dock.
  3. Install the phone dock assembly into the center console. See Phone Dock - Center Console (Remove and Replace).
  4. Raise the RH front window and close the RH front door.