2022-09-13

Panel - Lower Rear - Center Console (Remove and Replace)

Correction code 15195202 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Panel - Lower Rear - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the rear USB assembly to the center console lower rear panel
1 Nm (.7 lbs-ft)
  • Torx T10 bit
  • Ratchet/torque wrench
Reuse

Remove

  1. Release the clips (x7) that attach the center console lower rear panel to the center console.
  2. Disconnect the electrical harnesses from the USB assembly and the light, and then remove the center console lower rear panel from the vehicle.
  3. Remove the screws (x2) that attach the rear USB assembly to the center console lower rear panel.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Ratchet/torque wrench

Install

  1. Install the screws (x2) that attach the rear USB assembly to the center console lower rear panel.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Ratchet/torque wrench
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the USB sockets are properly aligned with the openings in the center console lower rear panel or damage may occur.
  2. Connect the USB assembly and light electrical harnesses to the center console lower rear panel.
  3. Position the center console lower rear panel to the center console, and then install the clips that attach the panel to the center console.