Collar - Static - Pivot - 2nd Row - LH (Remove and Replace)
Correction code
13057552
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace) .
- Remove the LH 2nd row seat back pivot bushing. See Pivot Bushing - Seat Back - 2nd Row - LH (Remove and Replace).
-
Use a combination wrench to hold the
pivot pin in place, and then use a screwdriver to pry the LH 2nd row pivot static collar
off the assembly.
NoteThe tabs (x6) may break during removal so the static collar cannot be reused.
Install
-
Install a new LH 2nd row pivot static
collar.
NoteEnsure the tabs (x6) are fully seated.
- Install the LH 2nd row seat back pivot bushing. See Pivot Bushing - Seat Back - 2nd Row - LH (Remove and Replace).
- Install the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace) .