Seal - Hood (Remove and Replace)
Correction code
11701802
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the LH front door.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace).
-
Remove the hood seal from the vehicle.
NoteNote orientation of the seal and any marking to allow re-installation into original position.TIpUse of the following tool(s) is recommended:
- Plastic trim tool
Install
-
Install the hood seal on the vehicle.
NoteLine up the seal marking with the center of the frunk. Verify seal is properly seated and aligned.
- Install the front underhood apron. See Underhood Apron - Front (Remove and Replace).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Close the LH front door.