01/04/2024 14:03:46

Sensor - Parking Distance - Inner - Front (HW3) (Remove and Replace)

Correction code 17271012 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

Informational PurposesAn informational icon, calling your attention
Note
This procedure is applicable to sensors S3 and S4.
  1. Disconnect LV Power. See LV Power (Disconnect and Connect).
  2. Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
  3. Disconnect the electrical harness from the parking distance sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  4. Release the parking distance sensor from the front fascia assembly.

Replace

  1. Install the parking distance sensor to the front fascia.
  2. Connect the electrical harness to the parking distance sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  3. Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
  4. Connect LV power. See LV Power (Disconnect and Connect).
    Informational PurposesAn informational icon, calling your attention
    Note
    After connecting LV power, do not shift the vehicle to Drive until the Toolbox routine (further below) is performed. Failure to do so can trigger vehicle alerts.
  5. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  6. In Toolbox, click the Actions tab, type TEST-RESET_PARKvia Toolbox: (link) into the search field, click TEST-RESET_PARKvia Toolbox: (link), click Run, and then allow the routine to complete.
  7. In Toolbox, click the Actions tab, type "USS Addresses" into the search field, click PROC_USM_FRONT_PROGRAM-USS-ADDRESSESvia Toolbox: (link)via Service Mode: Driver Assist ➜ Sensors ➜ Program Front USS, click Run, and then allow the routine to complete.
  8. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).