18/05/2023 15:22:47

Bezel - Seatbelt - C-Pillar - LH (Remove and Replace)

Correction code 15180032 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Fold the LH 2nd row seat back to the down position.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the seat cushion is not present, protect the seat as required.
  3. Release the lower tabs (x2) that attach the LH C-pillar seatbelt bezel to the upper C-pillar trim, and then remove the bezel from the upper C-pillar trim.
  4. Remove the bezel from the seatbelt.

Install

  1. Install the bezel onto the seatbelt.
  2. Install the bezel onto the upper C-pillar trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the upper portion of bezel onto the upper C-pillar trim, and then secure it in place with tabs (x2).
  3. Return the LH 2nd row seat to the vertical position.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove seat cushion protection, if added earlier in this procedure.
  4. Raise the LH rear window and the LH rear door.