17/06/2022 13:24:52

Harness - Fascia - Rear (HW3) (Remove and Replace)

Correction code 17101102 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
  1. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).
  2. Disconnect the electrical harness from the rear parking sensors (x6).
    Informational PurposesAn informational icon, calling your attention
    Note
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  3. Disconnect the electrical harness from the LH rear BLE module.
    Informational PurposesAn informational icon, calling your attention
    Note
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  4. Disconnect the electrical harness from the RH rear BLE module.
    Informational PurposesAn informational icon, calling your attention
    Note
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  5. Release the clips (x8) and adhesive pads (x4) that attach the rear fascia harness to the fascia, and then remove the harness from the fascia.
  6. Position the harness on the rear fascia, and then install the clips (x8) and adhesive pads (x4) that attach the harness to the fascia.
  7. Connect the electrical harness to the RH rear BLE module.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  8. Connect the electrical harness to the LH rear BLE module.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  9. Connect the electrical harness to the rear parking sensors (x6).
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  10. Install the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).