Substrate - Seat Back - 2nd Row - RH (Remove and Replace)
Correction code
13054802
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the RH 2nd row seat microphone. See Microphone - Seat - 2nd Row - RH (Remove and Replace).
- Remove the clips (x6) that attach the RH 2nd row substrate harness to the RH 2nd row seat back substrate.
Install
- Position the RH 2nd row substrate harness onto the RH 2nd row seat back substrate, and then install the clips (x6) that attach the harness to the substrate.
- Install the RH 2nd row seat microphone. See Microphone - Seat - 2nd Row - RH (Remove and Replace).