2022-06-17

Bumper Beam - Rear (Remove and Replace)

Correction code 10013102 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).
  2. Remove the nuts (x8) that attach the rear bumper beam to the body, and then remove the bumper beam from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • 3 in extension

Install

  1. Position the rear bumper beam onto the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Verify the "T" stamp is pointing downward to avoid fascia fitment issues.
  2. Install the nuts that attach the rear bumper beam to the body.
    60 Nm (44.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • 3 in extension
  3. Install the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install).