2023-06-27

Light - Fog/Reverse - Rear - LH (Global) (Remove and Replace)

Correction code 17402712 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
Note
This procedure is for the Global Refresh version of this part. The procedure for the Original version of this part is here: Light - Fog/Reverse - Rear - LH (Remove and Replace).

Remove

  1. Remove the lower liftgate trim assembly. See Trim - Liftgate - Lower (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the task light cover, task light, or liftgate switch from the trim assembly.
  2. Release the studs (x2) that attach the LH liftgate tail light side cover to the liftgate, and then remove the cover from the liftgate.
  3. Disconnect the LH rear fog/reverse light electrical connector.
  4. Remove the nuts (x4) that attach the LH rear fog/reverse light to the liftgate, and then remove the light from the liftgate.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket

Install

  1. Position the LH rear fog/reverse light into the liftgate, and then install the nuts (x4) that attach the light to the liftgate.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  2. Connect the LH rear fog/reverse light electrical connector.
  3. Position the LH liftgate tail light side cover onto the liftgate, and then secure the studs (x2) that attach the cover to the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the trim is properly fitted to the liftgate assembly.
  4. Install the lower liftgate trim assembly. See Trim - Liftgate - Lower (Remove and Replace).