Brake Rotors - Rear - Set (Remove and Replace)
Correction code
33011402
0.78
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
- 2024-06-04: Updated EPB Service Mode reference.
- 2023-11-09: Updated rear caliper to knuckle torque to 115 Nm.
- 2023-10-25: Updated EPB Service Mode reference.
- 2023-10-16: Added step to make sure caliper piston face is aligned for Mando calipers.
Remove
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Remove both rear wheels. See Wheel Assembly (Remove and Install).
- Place the vehicle into EPB Service Mode. See Park Brake Caliper - Release.
-
Disconnect the EPB harness connector
from the LH caliper motor.
CAUTIONPush the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
- Remove the bolts that attach the LH rear brake caliper to the LH rear knuckle and hang the caliper from the body of the vehicle using an S-hook.
-
If installed, remove and discard
the bolt that attaches the brake rotor to the hub.
NoteA new bolt will not be installed.TIpUse of the following tool(s) is recommended:
- 13 mm socket
- Repeat step 4 through step 6 for the RH side of the vehicle.
Install
-
Position the LH front rotor to the
knuckle assembly.
NoteIt is not necessary to install the bolt that attaches the rotor to the hub.
-
If a Mando caliper, perform these
additional substeps.
-
Remove the S-hook and install the
bolts that attach the LH rear brake caliper to the knuckle.
Note2x bolts, E18, 115 Nm
-
Connect the LH EPB caliper harness
connector.
CAUTIONPush the red locking tab into the connector to engage the connector lock.
- Repeat steps 1 and 4 for the RH side of the vehicle.
- Hold the brake pedal and select "Park" on the touchscreen to disable the EPB service mode.
- Install both rear wheels. See Wheel Assembly (Remove and Install).
- Lower the vehicle.
- Perform a vehicle road test using a series of ABS-active stops and make sure proper brake pedal feel and performance is achieved.