2022-06-17

Body Damper - Liftgate - LH (Remove and Replace)

Correction code 11330052 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Remove the screws (x2) that attach the LH liftgate body damper to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Stubby ratchet/stubby torque wrench

Install

  1. Position the LH liftgate body damper onto the body, and then install the screws (x2) that attach the damper to the body.
    12 Nm (8.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Stubby ratchet/stubby torque wrench
  2. Close the liftgate to check for gap/flushness.
  3. Adjust the LH liftgate body damper if necessary.