Wiper Arm - LH (Remove and Replace)
Correction code 17500302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
-
Disconnect the hose that attaches the
LH wiper arm to the nozzle.
-
Remove the LH wiper arm nut
cover.
-
Remove the LH wiper arm nut and
release the wiper arm assembly.
Note1x nut, 15mm, 26 NmNoteUse special tool Wiper Arm Removal Tool 1058696-00-A to release the wiper arm.
Install
-
Position the wiper arm to the vehicle
and line up the wiper blade to the reference mark on the windshield, then install the
nut that attaches the wiper arm to the vehicle.
Note1x nut, 15mm, 26 Nm
-
Install the LH wiper arm nut
cover.
-
Connect the LH wiper arm hose to the
washer nozzle.