17/06/2022 13:07:47

Closeout Panel - Door - Rear - LH (Remove and Replace)

Correction code 11701452 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  2. Remove the butyl patch that covers the closeout panel opening.
  3. Pull the white tab to release the connector lock, and then disconnect the LH rear door handle controller electrical connector.
  4. Remove the screw that attaches the LH rear door handle controller to the LH rear door closeout panel.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
  5. Release the retainer tabs that attach the LH rear door handle controller to the closeout panel assembly, and then remove the controller from the assembly.
  6. Disconnect the LH rear door pressure sensor electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  7. Remove the bolts (x6) that attach the LH rear door closeout panel to the door assembly.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 8 mm socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
  8. Release the clips (x3) that attach the wiring harness to the LH rear door closeout panel, and then remove the closeout panel from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the clips from the back of panel to prevent damage.

Install

  1. Install the LH rear door closeout panel onto the LH rear door, and then install the bolts (x6) that attach the closeout panel to the door assembly.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 8 mm socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
  2. Position the wiring harness onto the LH rear door closeout panel, and then install the clips (x3) that attach the harness to the closeout panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure there is an audible click to fully engage the clip.
  3. Connect the LH rear door pressure sensor electrical connector, and then engage the connector lock.
  4. Install the LH rear door handle controller onto the closeout panel assembly.
  5. Install the screw that attaches the LH rear door handle controller to the LH rear door closeout panel.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
  6. Connect the LH rear door handle controller electrical connector, and then engage the connector lock.
  7. Install the butyl patch that covers the closeout panel opening.
  8. Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).