17/06/2022 13:18:23

Bracket - Trim - Liftgate - LH (Remove and Replace)

Correction code 15110032 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  2. Remove the liftgate speaker grille. See Grille - Speaker - Liftgate (Remove and Replace).
  3. Remove the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
  4. Remove the small clip on the LH liftgate trim bracket.
  5. Release the larger clip from the LH liftgate trim bracket.
  6. Disconnect the LH FM/XM antenna electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    This will allow clearance for the removal of the LH liftgate trim bracket without damaging the wires and connector.
  7. Release the clips (x3) that attach the LH liftgate trim bracket, and then remove the bracket from the liftgate.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If using a metal clip trim tool, use a plastic trim tool behind the metal trim tool to push against the liftgate to avoid damage to the paint. Pull bracket back towards the end of the liftgate once unclipped.

Install

  1. Position the LH liftgate trim bracket into the liftgate, and then install the clips (x3) that attach the bracket to the liftgate.
  2. Connect the LH FM/XM antenna electrical connector.
  3. Install the small clip on the LH liftgate trim bracket.
  4. Install the larger clip from the LH liftgate trim bracket.
  5. Install the liftgate upper trim. See Trim - Upper - Liftgate (Remove and Replace).
  6. Install the liftgate speaker grille. See Grille - Speaker - Liftgate (Remove and Replace).
  7. Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).