Duct - Under Floor to Rear Cabin (Remove and Replace)
Correction code
18104502
0.42
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open all four doors.
- Lower all four windows.
- Move the LH and RH front seats forward.
- Remove the center console lower rear panel. See Panel - Lower Rear - Center Console (Remove and Replace).
- Remove the center console assembly. See Center Console Assembly (Remove and Replace).
-
Release the brush clip that attaches the under floor to rear cabin duct to the body, and then remove the duct from the vehicle.
Tip: Use of the following tool(s) is recommended:
- Clip pry tool
Install
-
Position the under floor to rear cabin duct on the vehicle, and then install the brush clip that attaches the duct to the body.
NoteSlide the duct into the HVAC assembly and ensure the duct is fully seated.
- Install the center console assembly. See Center Console Assembly (Remove and Replace).
- Install the center console lower rear panel. See Panel - Lower Rear - Center Console (Remove and Replace).
- Move the LH and RH front seats to original position.
- Raise all four windows.
- Close all four doors.