17/06/2022 13:29:28

Reservoir - Windshield Washer (Remove and Replace)

Correction code 17501102 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
  3. Disconnect the shock tower hose from the washer tank hose.
  4. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  5. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  6. Remove the washer system. See System - Windshield Washer (Remove and Replace).
  7. Remove the horn assembly. See Horn Assembly (Remove and Replace).
  8. Remove the washer level sensor from the washer reservoir. See Sensor - Level - Windshield Washer Reservoir (Remove and Replace).
  9. Release the retainer clip that attaches the washer hose the reservoir.
  10. Release the washer hose from the hooks (x3) that attach the hose to the reservoir.
  11. Remove the washer fluid pump from the washer reservoir. See Pump - Windshield Washer Reservoir (Remove and Replace).
  12. Remove the washer cap from the washer reservoir. See Cap - Reservoir - Windshield Washer (Remove and Replace).

Install

  1. Install the washer cap to the washer reservoir. See Cap - Reservoir - Windshield Washer (Remove and Replace).
  2. Install the washer pump to the washer reservoir. See Pump - Windshield Washer Reservoir (Remove and Replace).
  3. Install the washer hose to the hooks (x3) on the reservoir.
  4. Install the retainer clip that attaches the washer hose to the reservoir.
  5. Install the washer level sensor. See Sensor - Level - Windshield Washer Reservoir (Remove and Replace).
  6. Install the horn assembly. See Horn Assembly (Remove and Replace).
  7. Install the washer system. See System - Windshield Washer (Remove and Replace).
  8. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  9. Remove the vehicle from the lift.
  10. Connect the shock tower hose to the washer tank hose.
  11. Install the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
  12. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  13. Fill the washer fluid reservoir.
    Tip: The reservoir has a capacity of 4.5 liters.