Collar - Static - Pivot - 2nd Row - RH (Remove and Replace)
    
     Correction code
    
                                    13057562
                                    0.06
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
    Correction code
    
                                    13057562
                                    0.06
                                    
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
  
Remove
- Remove the RH 2nd row seat back from the vehicle. See Seat Back - 2nd Row - RH (Remove and Replace).
- Remove the RH 2nd row seat back pivot bushing. See Pivot Bushing - Seat Back - 2nd Row - RH (Remove and Replace).
- 
          Use a combination wrench to hold the
            pivot pin in place, and then use a screwdriver to pry the RH 2nd row pivot static collar
            off the assembly.
          NoteThe tabs (x6) may break during removal so the static collar cannot be reused.
Install
- 
          Install a new RH 2nd row pivot static
              collar.
          NoteEnsure the tabs (x6) are fully seated.
- Install the RH 2nd row seat back pivot bushing. See Pivot Bushing - Seat Back - 2nd Row - RH (Remove and Replace).
- Install the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).