06/07/2023 01:17:54

Actuator - Pedestrian Protection - LH (EMEA) (Remove and Replace)

Correction code 20300122 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-07-06: Reorganized the procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH and RH underhood apron. See Underhood Apron - LH (Remove and Replace)
  4. Disconnect LV power. See LV Power (Disconnect and Connect).
  5. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  6. Remove the clips (x6) that attach the LH front wheel liner to the vehicle to partially release the rear portion of the LH front wheel liner, then move it aside.
  7. Pull the locking tab outward to disconnect the LH pedestrian protection actuator electrical connector.
  8. Release the clip that attaches the LH pedestrian protection actuator electrical connector to the body.
  9. Lower the vehicle. See Raise Vehicle - 2 Post Lift.
  10. Remove the LH and RH wiper arm. See Wiper Arm - LH (Remove and Replace).
  11. Remove the LH and RH shock tower cover. See Cover - Shock Tower - LH (Remove and Replace).
  12. Remove the cowl screen washer hose. See Hose - Washer - Cowl Screen (Remove and Replace).
  13. Remove the bolts (x2) that attach the LH pedestrian protection actuator to the vehicle.

Install

  1. Install the bolts (x2) that attach the LH pedestrian protection actuator to the vehicle.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • 4 in extension
    • Ratchet/torque wrench
  2. Raise the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Install the clip that attaches the LH pedestrian protection actuator electrical connector to the body.
  4. Connect the LH pedestrian protection actuator electrical connector.
  5. Install the clips (x6) that attach the LH front wheel liner to the vehicle.
  6. Install the LH front wheel. See Wheel Assembly (Remove and Install)
  7. Connect LV power. See LV Power (Disconnect and Connect).
  8. Install the cowl screen washer hose. See Hose - Washer - Cowl Screen (Remove and Replace)
  9. .Install the LH and RH wiper arm. See Wiper Arm - LH (Remove and Replace)
  10. Install the LH and RH shock tower cover. See Cover - Shock Tower - LH (Remove and Replace).
  11. Install the LH and RH underhood apron. See Underhood Apron - LH (Remove and Replace)
  12. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  13. Remove the vehicle from the 2 post lift. See Raise Vehicle - 2 Post Lift.