Closeout - Armrest - 2nd Row (Remove and Replace)
Correction code 13058012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
- Open the LH rear door.
- Fold down the LH second row seat.
-
Release the clips that attach the seat
back panel to the seat, and then slide the seat back panel out of the bottom of the seat
frame.
- Raise the LH second row seat.
- Press the button behind the center headrest and lower the armrest.
-
Release the clip in the center armrest
closeout, and then lift the center armrest closeout upwards and away from the backrest
frame.
Replace
-
Position the center armrest closeout
tabs on to the backrest frame, and then install the clip that attaches the center
armrest closeout to the backrest frame.
- Return the armrest to it's original position.
- Fold down the LH second row seat.
-
Position the seat back panel to the
seat, and then install the clips that attach the seat back panel to the seat.
- Raise the LH second row seat.
- Close the LH rear door.
- Install the parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).