Harness - Tuner - Liftgate (Remove and Replace)
Correction code
17104512
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the liftgate.
- Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
- Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
- Remove the liftgate speaker grille. See Grille - Speaker - Liftgate (Remove and Replace).
- Remove the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
- Disconnect the chimsel connector.
- Release the liftgate tuner harness from the chimsel BIW bracket holding clips (x4).
- Disconnect the liftgate harness from the tuner harness.
- Release the clips (x2) that attach the rear defrost grid harness to the tuner harness.
- Release the clips (x3) that attach the tuner harness to RH BIW sonic bracket.
- Disconnect the connectors (x2) to the RH antenna amplifier.
- Release the RH liftgate harness from the tuner harness clips (x2).
- Remove the clips (x6) that attach the tuner harness to the liftgate BIW.
- Disconnect the coax connector on the radio tuner.
- Release the LH sonic bracket clip.
- Release the locking tab, and then disconnect the LH FM antenna amplifier connector.
-
Remove the liftgate tuner harness from
the liftgate.
NoteTake note of the routing on the tuner harness behind the RH liftgate harness for installation.
Install
-
Position the liftgate tuner harness into the liftgate.
NoteTake note of the routing on the tuner harness behind the RH liftgate harness.
- Connect the LH FM antenna amplifier connector, and then secure the locking tab.
- Secure the LH sonic bracket clip.
- Secure the clips (x6) that attach the tuner harness to the liftgate BIW.
- Secure the RH liftgate harness to the tuner harness clips (x2).
- Connect the coax connector on the radio tuner.
- Connect the liftgate harness to the tuner harness.
- Secure the clips (x2) that attach the rear defrost grid harness to the tuner harness.
- Secure the clips (x3) that attach the tuner harness to RH BIW sonic bracket.
- Connect the connectors (x2) to the RH antenna amplifier.
- Secure the liftgate tuner harness to the chimsel BIW bracket holding clips (x4).
- Connect the chimsel connector.
- Install the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
- Install the liftgate speaker grille. See Grille - Speaker - Liftgate (Remove and Replace).
- Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
- Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
- Close the liftgate.