17/06/2022 13:06:04

Striker - Liftgate (Remove and Replace)

Correction code 11353402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Striker - Liftgate (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the liftgate striker to the vehicle
10 Nm (7.4 lbs-ft)
  • Torx T30 socket
  • 6 in extension
  • Ratchet/torque wrench
 Reuse

Remove

  1. Open the liftgate.
  2. Release the six clips that attach the sill panel to the vehicle, and then remove the sill panel from the vehicle.
  3. Use masking tape to mark the position of the liftgate striker to the vehicle.
  4. Remove the two bolts that attach the liftgate striker to vehicle, and then remove the liftgate striker from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 6 in extension
    • Ratchet/torque wrench

Install

  1. Using the masking tape as a guide, install the liftgate striker to the vehicle, but do not fully torque the bolts.
  2. Close the liftgate and use the gap and flush tool to verify the liftgate alignment is within specification.
  3. Open the liftgate and adjust the striker position as necessary.
  4. Torque the bolts that attach the liftgate striker to the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 6 in extension
    • Ratchet/torque wrench
  5. Remove masking tape around the liftgate striker.
  6. Position the six clips that attach the sill panel to the vehicle, and then install the sill panel to the vehicle.
  7. Close the liftgate.