2022-06-17

Noise Filter - LV - Antenna (Remove and Replace)

Correction code 21300502 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  2. Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  3. Remove the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
  4. Disconnect the Antenna 12V noise filter from the RH side of the liftgate glass.
  5. Disconnect the rear defrost grid harness from the antenna 12V noise filter.
  6. Remove the screw that attaches the antenna 12V noise filter to the liftgate, and then remove the noise filter from the liftgate.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T30 bit
    Informational PurposesAn informational icon, calling your attention
    Note
    The screw is self contained to the noise filter.

Install

  1. Position the antenna 12V noise filter onto the liftgate, and then install the screw that attaches the noise filter to the liftgate.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T30 bit
  2. Connect the rear defrost grid harness to the antenna 12V noise filter.
  3. Connect the Antenna 12V noise filter to the RH side of the liftgate glass.
  4. Install the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
  5. Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  6. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).