24/05/2023 04:10:25

Door Glass - Front - LH (Remove and Replace)

Correction code 11500102 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-05-24: Added cleaning instructions to prevent glass damage.

Remove

  1. Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  2. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  3. Remove the butyl patches that cover the openings in the LH front door.
  4. Temporarily connect the puddle lamp to the LH front door harness.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Route the harness and lamp wiring so it will not be damaged when closing the door.
  5. Connect the window switch special tool to the LH front door harness.
  6. Latch the LH front door to allow the window to raise fully.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT close the door with the window in this position as the upper bright trim will be damaged.
  7. Using the window switch special tool, raise the LH front window fully.
  8. Remove the bolts (x2) that attach the LH front door glass to the LH front regulator isolator clamps.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  9. Remove the LH A-pillar margin front door seal. See Seal - Door - Front - Margin - A Pillar - LH (Remove and Replace).
  10. Release the clips (x2) that attach the LH front door margin seal to the LH front door, and then set the seal aside.
  11. Remove the LH front door inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace).
  12. Remove the LH front door glass from the door assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Place the glass on a clean and protected surface.

Install

  1. Inspect the regulator isolator clamps for glass splinters or other debris, and clean them if necessary.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Debris and splinters may damage or shatter the new door glass.
  2. Position the LH front door glass into the door assembly.
  3. Remove the LH front door inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace).
  4. Secure the clips (x2) that attach the LH front door margin seal to the LH front door, and then set the seal aside.
  5. Install and hand-tighten the bolts (x2) that attach the LH front door glass to the LH front regulator isolator clamps.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Adjust the LH front door glass. See Door Glass - Front - LH (Adjust)