2026-09-25

Buckle - 1st Row - LH (Remove and Replace)

Correction code 20054702 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See Air Bag and Supplementary Restraint System (SRS) Precautions
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Move the driver seat to the most rearward and lowest position.
  3. Open the LH rear door.
  4. Disconnect LV power. See LV Power (Disconnect and Connect).
  5. Remove the driver seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
  6. Disconnect the driver seat buckle electrical connector.
  7. Remove and discard the bolt that attaches LH 1st row buckle from the seat track.
    40 Nm (29.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • T45P socket

Install

  1. Position the driver seat buckle into the vehicle, and then install a new bolt that attaches the buckle to the seat track.
    40 Nm (29.5 lbs-ft)
    Note
    Align the guide pin onto the seat track.
    Tip
    Use of the following tool(s) is recommended:
    • T45P socket
  2. Connect the driver seat buckle electrical connector.
  3. Install the driver seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
  4. Connect LV power. See LV Power (Disconnect and Connect).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  6. Move the driver seat to the original position.