2022-06-17

Speaker - Pedestrian Warning (Remove and Replace)

Correction code 17541002 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the valance from the front aero shield. See Valance - Front Fascia (Remove and Replace).
  3. Remove the clips (x3) that attach the RH wheelhouse liner to the front fascia.
  4. Disconnect and release pedestrian warning speaker electrical harness.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  5. Remove the screws (x3) that attach the pedestrian warning speaker to the front fascia.

Install

  1. Install the screws (x3) that attach the pedestrian warning speaker to the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    3x screws, T25, 1.8 Nm
  2. Install the pedestrian warning speaker electrical harness.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Push the red locking tab into the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.
  3. Install the clips (x3) that attach the RH wheelhouse liner to the front fascia.
  4. Install the valance to the front aero shield. See Valance - Front Fascia (Remove and Replace).
  5. Remove the vehicle from the lift.