17/06/2022 13:07:44

Acoustic Foam - Inner - Front Door - LH (Remove and Replace)

Correction code 11700012 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  2. Remove the LH front door panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  3. Release the clip that attaches the top corner of the LH front door seal to the door assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the seal tucked behind the fixed glass.
  4. Remove the LH front door inner acoustic foam.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of any additional NVH/fitment countermeasures in the area.

Install

  1. Remove the adhesive backing, and then position the LH front door inner acoustic foam into the door assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any additional NVH/fitment countermeasures that were present on removal.
  2. Place the top corner of the LH front door seal back into position, and then fasten the clip that attaches the seal to the door assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tuck the front edge of the seal behind the fixed glass.
  3. Install the LH front door panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  4. Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  5. Close the LH front door.
  6. Check the gap fitment of the LH front door trim decor to the IP decor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current specification targets.
  7. Open the LH front door.
  8. Rotate the adjustment nut to adjust the LH front door trim as necessary.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 18 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • 6 in extension
    • Torx T30 socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Loosen the T30 nut and rotate nut to achieve desired specification. Rotate clockwise to close the gap, and counterclockwise to tighten the gap. Torque the T30 fastener to lock.
  9. Install the LH front door trim decor. See .
  10. Close the LH front door.
  11. Check the gap fitment of the LH front door trim decor to the IP decor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current specification targets.