2022-06-17

Bracket - Radar - Front (Remove and Replace)

Correction code 17201802 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bracket - Radar - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the radar bracket to the vehicle
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • 2 in extension
  • Flex head ratchet/flex head torque wrench
 Reuse

Install

  1. Remove the front fascia. See: Fascia Assembly - Front (Remove and Install).
  2. Disconnect the electrical harness from the radar.
  3. Release the tab that attaches the radar to the radar bracket.
  4. Remove the three bolts that attach the radar bracket to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use one hand to hold the bracket steady while removing the bolts to prevent the bracket from flexing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    • Flex head ratchet/flex head torque wrench

Install

  1. Position the radar bracket to the vehicle, and then install the bolts that attach the radar bracket to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use one hand to hold the bracket steady while removing the bolts to prevent the bracket from flexing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    • Flex head ratchet/flex head torque wrench
  2. Position the radar into the bottom of the radar bracket, and then install the radar to the top radar bracket clip.
  3. Connect the electrical harness to the radar.
  4. Install the front fascia. See Fascia Assembly - Front (Remove and Install).
  5. Perform the radar calibration. See .