2024-09-04

Seat Cushion - Lower - 2nd Row (Remove and Replace)

Correction code 13051002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-09-04: Added note to perform ISOFIX flap retrofit for older vehicles.

Remove

  1. Remove the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  2. Disengage the locking clips (x2), lift up on the 2nd row lower seat cushion, disconnect the electrical connectors (x2), and then remove the lower seat cushion from the vehicle.

Install

Informational PurposesAn informational icon, calling your attention
Note
Vehicles built before August 17, 2021 require the ISOFIX flap (pair) to be retrofitted for proper fitment with new lower seat cushions. If the retrofit is performed, add correction code 13050006. See Flap - ISOFIX - Pair (Retrofit).
  1. Position the 2nd row lower seat cushion into the vehicle, connect the electrical connectors (x2), slide the seat buckles through the cushion, and then engage the locking clips (x2).
  2. Install the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).