2022-06-17

Bun - Armrest - 2nd Row (Remove and Replace)

Correction code 13050092 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row back seat panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).
  2. Remove the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace).
  3. Place the LH 2nd row seat back assembly upside down on a padded workbench.
  4. Remove the bolt that attaches the LH 2nd row seat bolster assembly to the back frame.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Position the seat back assembly upright on the padded workbench.
  6. Release the clips (x2) that attach the LH 2nd row bolster assembly to the seat assembly, and then remove the bolster from the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lightly squeeze the clips to release the sub-bolster.
  7. Remove the clips (x2) that attach the 2nd row armrest bun to the seat assembly.
  8. Release the clips (x3) that attach the 2nd row armrest bun to the seat back assembly, and then remove the bun from the assembly.

Install

  1. Install the clips (x3) that attach the 2nd row armrest bun to the seat back assembly.
  2. Install the clips (x2) that attach the 2nd row armrest bun to the seat assembly.
  3. Install the clips (x2) that attach the LH 2nd row bolster assembly to the seat assembly.
  4. Position the seat back assembly upside down on the padded workbench.
  5. Install the bolt that attaches the LH 2nd row seat bolster assembly to the back frame.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Install the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace).
  7. Install the LH 2nd row back seat panel. See Back Panel – 2nd Row Seat – LH (Remove and Replace).