2022-06-17

Puddle Light - Rear Door - LH (Remove and Replace)

Correction code 17352202 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  3. Release the tabs (x3) that attach the LH rear door puddle light lens to the LH rear door trim panel, and then remove the lens from the assembly.
  4. Release the tab that attaches the LH rear door puddle light to the LH rear door trim panel, disconnect the electrical connector, and then remove the puddle light from the trim panel.

Install

  1. Position the LH rear door puddle light into the LH rear door trim panel, connect the electrical connector, and then install the puddle light into the trim panel.
  2. Install the LH rear door puddle light lens into the LH rear door trim panel.
  3. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  4. Raise the LH rear window and close the LH rear door.