2022-06-17

Diffuser - Rear Fascia (Remove and Replace)

Correction code 12030802 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Diffuser - Rear Fascia (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x6) and nuts (x3) that attach the rear fascia diffuser to the underbody
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • Ratchet/torque wrench
  • 6 in extension
 Reuse

Remove

  1. Raise the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift.
  2. Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
  3. Carefully remove the plastic screws (x2) that attach the tow hitch cover to the rear fascia diffuser.
    Informational PurposesAn informational icon, calling your attention
    Note
    Avoid damage to the plastic screws because they are captive.
  4. Release the tabs (x10) that attach the tow hitch cover to the rear fascia diffuser, and then remove the cover from the diffuser.
  5. Release the push clips (x6) that attach the rear fascia diffuser to the LH and RH rear wheel arch liners.
  6. Remove the bolts (x6) and nuts (x3) that attach the rear fascia diffuser to the underbody.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Ratchet/torque wrench
    • 6 in extension
  7. Release the tabs (x8) that attach the rear fascia diffuser to the rear fascia, and then remove the diffuser from the vehicle.

Install

  1. Fasten the tabs (x8) that attach the diffuser to the fascia, and then install the bolts (x6) and nuts (x3) that attach the rear fascia diffuser to the underbody.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Ratchet/torque wrench
    • 6 in extension
  2. Fasten the push clips (x6) that attach the rear fascia diffuser to the LH and RH rear wheel arch liners.
  3. Install the tow hitch cover to the rear fascia diffuser, and then fasten the tabs (x10) that attach the cover to the diffuser.
  4. Carefully install the plastic screws (x2) that attach the tow hitch cover to the rear fascia diffuser.
  5. Install the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
  6. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.