2022-06-17

Actuator - Flap - Center Console - LH (Remove and Replace)

Correction code 18102702 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the center console air wave assembly. See Air Wave Assembly - Center Console (Remove and Replace).
  2. Remove the screws (x2) that attach the LH center console flap actuator to the center console, and then remove the actuator from the vehicle.
    NaN Nm (NaN lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 bit

Install

  1. Position the LH center console flap actuator into the center console, and then install the bolts (x2) that attach the actuator to the center console.
    NaN Nm (NaN lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the keyed socket is aligned with the flap gear.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not force the actuator onto the center console if the socket is misaligned.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T20 bit
  2. Install the center console air wave assembly. See Air Wave Assembly - Center Console (Remove and Replace).