2025-03-12

Center Console - Cup Holder Lower Assembly (Remove and Replace)

Correction code 1519020702 FRT 0.25 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Table 1. Torque Specifications:Assembly - USB Hub (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts secure the VC USB to
1.1 Nm (.8 lbs-ft)
  • Torx T20 bit
  • DRIVER KIT, 1/4" HEX, M12
  • 4 in extension
 Reuse

Remove

  1. Remove the rear end module. See Module - Rear End - Center Console (Remove and Install).
  2. Disconnect VC USB module connector.
  3. Remove the cup holder.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • DRIVER KIT, 1/4" HEX, M12
    • 4 in extension

Install

  1. Install VC USB to center console.
    1.1 Nm (.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • DRIVER KIT, 1/4" HEX, M12
    • 4 in extension
  2. Connect VC USB module connector.
  3. Install the rear end module. See Module - Rear End - Center Console (Remove and Install).