Link - Fore - Upper - Rear - LH (Remove and Replace)
Correction code 31031402 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Nut and bolt that attaches the rear upper fore link to the knuckle |
|
|
Reuse | |
Bolts (x2) that attach the rear upper fore link to the subframe |
|
|
Reuse | |
Bolt that attaches the ride height sensor arm to the upper fore link |
|
|
Reuse |
Remove
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift
- Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
-
Remove the bolt that attaches the ride
height sensor arm to the LH upper fore link.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
-
Remove the bolts (x2) that attach the
LH rear upper fore link to the subframe.
Tip: Use of the following tool(s) is recommended:
- 16 mm socket
-
Remove the bolt that attaches the LH
rear upper fore link to the knuckle, and then remove the upper fore link from the
vehicle.
Tip: Use of the following tool(s) is recommended:
- 21 mm socket
Install
-
Position the LH upper fore link to the
knuckle, and then install and hand tighten the bolt that attaches the link to the
knuckle.
NoteThe bolt will be torqued at a later step.Tip: Use of the following tool(s) is recommended:
- 21 mm socket
-
Install the bolts (x2) that attach the
LH rear upper fore link to the subframe.Tip: Use of the following tool(s) is recommended:
- 16 mm socket
-
Install the bolt that attaches the LH
ride height sensor arm to the LH upper fore link.CAUTIONDo not bind or invert the orientation of the sensor arm.Tip: Use of the following tool(s) is recommended:
- 10 mm socket
-
If installed, remove and discard
the bolt that attaches the brake rotor to the hub.
NoteA new bolt will not be installed.Tip: Use of the following tool(s) is recommended:
- 13 mm socket
-
Install a hub jack adapter onto the LH
rear hub, and then use a support stand to support the LH rear suspension at ride height
(85 mm +/- 5 mm).
NoteMeasure the distance from the upper fore link to the bolt on the frame rail to make sure LH suspension is set to ride height.Tip: Use of the following tool(s) is recommended:
- Hub Jack Adapter - 1459409-00-A
-
Torque the bolt that attaches the LH
rear upper fore link to the knuckle, and then mark the bolt with a paint pen.Tip: Use of the following tool(s) is recommended:
- 21 mm socket
- Lower the support stand until the suspension is unladen, then remove it from the vehicle.
- Remove the hub jack adapter from the hub.
- Install the LH rear wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.