05/08/2022 15:33:53

Pipe - Brake Junction to Jounce - LH (Remove and Replace)

Correction code 33030052 3.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the brake front pipe assembly. See Pipe Assembly - Front - Brake (Remove and Replace).
  2. Release the nut that attaches the front end of the LH front brake pipe to the jounce hose.
    16 Nm (11.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 12 mm ratcheting combination wrench flex head
  3. Release the LH front brake pipe clips (x3).
  4. Remove the LH brake junction to jounce pipe:
    1. Guide the front of brake pipe up and over the AC compressor.
    2. Guide the rear of the brake pipe under the steering column and over the body casting.
    3. Guide the brake pipe towards the front of the vehicle between the superbeam and the AC compressor, and then tilt the brake pipe into vertical position.
    4. Guide the rear of the brake pipe out.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not bend the brake pipe.

Install

  1. Install the LH brake junction to jounce pipe:
    1. Guide the rear of the brake pipe between the superbeam and the AC compressor in vertical position.
    2. Tilt the brake pipe into horizontal position, and then guide towards the rear of the vehicle.
    3. Guide the rear of the brake pipe over the body casting and under the steering column.
    4. Guide the front of the brake pipe over the AC compressor, and then position the brake pipe for installation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not bend the brake pipe.
  2. Secure the LH front brake pipe onto clips (x3).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not bend the brake pipe.
  3. Install the nut that attaches the front end of the LH front brake pipe to the jounce hose.
    16 Nm (11.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 12 mm ratcheting combination wrench flex head
  4. Install the brake front pipe assembly. See Pipe Assembly - Front - Brake (Remove and Replace).