Buckle - 1st Row - LH (Remove and Replace)
Correction code
20054702
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the LH front door.
- Lower the LH front window.
- Move the LH front seat backwards.
- Open the RH falcon wing door.
- Remove the driver seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
-
Disconnect the LH 1st row buckle
harness connector from the seat.
TIpUse of the following tool(s) is recommended:
- Small flat head screwdriver
-
Remove the bolt that attaches the LH
1st row buckle to the seat, and then remove the buckle from the vehicle.
TIpUse of the following tool(s) is recommended:
- 3 in extension
- Ratchet/torque wrench
- Torx T50 socket
Install
-
Position the LH 1st row buckle onto
the seat, and then install the bolt that attaches the buckle to the seat.45 Nm (33.2 lbs-ft)TIpUse of the following tool(s) is recommended:
- 3 in extension
- Flex head ratchet/flex head torque wrench
- Ratchet/torque wrench
- Torx T50 socket
- Connect the LH 1st row buckle harness connector to the seat.
- Install the driver seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
- Close the RH falcon wing door.
- Raise the LH front window.
- Close the LH front door.